Hammerhead 250 has milk for oil after about 3 minutes of run time. Replaced the head gasket, but it's still taking on water. Although there is no sign of oil in the coolant. Any suggestions on next steps?
Hammerhead 250 has milk for oil after about 3 minutes of run time. Replaced the head gasket, but it's still taking on water. Although there is no sign of oil in the coolant. Any suggestions on next steps?
Thanks!
Water pump seal? Pinhole in the cylinder around the water jacket?
_________________ Ron
2009 Hammerhead 250SS (it's got a few mods) Joylaris 400 Gone, but not forgotten: 2005 Carter Talon, 2007 Hammerhead 250SS Proud member of Team FIB
Joined: Sat Dec 24, 2005 2:51 pm Posts: 112 Location: Moundsville, West Virginia
Did you flush/clean all the water out after changing the head gasket? Just wondering if there was any water left in there that contaminated the fresh oil?
_________________ "I wish there was a way to tell you're in the good old days, before you've actually left them."
Users browsing this forum: No registered users and 1 guest
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
