| Author |
Message |
| < Modifications - Mini Off Road Kart ~ choke problem on a cv carb + Adding a primer |
|
|
|
|
Next get a 1/8" brass (preferred) fitting and cut it to about 1/2" in length. Mount it into a drill chuck and thin down the bottom end by lightly squeezing with a pliers as it spins. Stop when it just fits into the hole.
_________________
_________________
2 Polaris RZRs & a Dune 150. Ridge Runner--Gone. Yerfdog 3206--Gone (but you never forget your 1st!).
Buggy pictures, mods, ideas, how-to's:
http://tinyurl.com/8ltm8
Last edited by guy48065 on Mon Jul 31, 2006 9:42 pm; edited 1 time in total
|
|
|
|
 |
Sponsor
|
|
|
|
|
|
|
Mix about a teaspoon of epoxy and dribble it into the recess until it covers the holes and the brass nipple.
_________________
_________________
2 Polaris RZRs & a Dune 150. Ridge Runner--Gone. Yerfdog 3206--Gone (but you never forget your 1st!).
Buggy pictures, mods, ideas, how-to's:
http://tinyurl.com/8ltm8
|
|
|
|
|
|
|
|
|
The CV carb has a drain fitting at the bottom of the fuel bowl that can be opened and used as the fuel source for the primer rather than adding a tee in the fuel line. Just to make sure fuel always flows thru this drain I ground a flat in the needle and lightly screwed it all the way in.
_________________
_________________
2 Polaris RZRs & a Dune 150. Ridge Runner--Gone. Yerfdog 3206--Gone (but you never forget your 1st!).
Buggy pictures, mods, ideas, how-to's:
http://tinyurl.com/8ltm8
|
|
|
|
|
Sponsor
|
|
|
|
|
|
|
And the other posts and websites can take it from there...
_________________
_________________
2 Polaris RZRs & a Dune 150. Ridge Runner--Gone. Yerfdog 3206--Gone (but you never forget your 1st!).
Buggy pictures, mods, ideas, how-to's:
http://tinyurl.com/8ltm8
|
|
|
|
|
|
Articles
