Hi
I've just bought a second hand Xinling 250 buggy and one of the drive chains keeps falling off as its too slack. I can't work out how to tension it and wondered if anyone could give me some pointers on this?
Can you post a picture of the rear end please? _________________ Custom Buggy http://www.buggynews.com/topic13417.html
Sahara 150cc Converted to a 350
Kasea AB150
Blade 50cc
Polaris Sportsman 700 Twin
ok i have seen your pic
looks identical to my titan
the three alen bolts at the end of the arm loosen them and you should be able to get it to spin a little its hard did you buy it new ? if you did you should have a tool that goes in to holes in the hub that makes it a million time easier _________________ 06 joyner 250 sand viper,red metallic..blue clutch spring 17 gram sliders
ok what i did was took the largest Allen wrench i had and a extended for sockets and put that on the whole closest to the front get it as loose as possible by loosening the allen bolts as far as possible you may have to jam a screw driver in there to get it to loosen enough to spin good luck _________________ 06 joyner 250 sand viper,red metallic..blue clutch spring 17 gram sliders
Articles
