So if the gear box is not supposed to wobble, the only thing it could be is bolts not tight,a warped shaft going into the tranny,or could it be something wrong or out of align in the reverse box?
Ichecked all the bolts on the reverse gear box and bracket, they were all tight.Is it possible that something is misaligned or broke in the reverse gear box? Could you talk me thru taking the box off so i dont diconnect something i should't.
Is anyone still out there? What else do you think might cause the reverse gear case wobble,and how could i fix it before it tears anything up.Please give more advise if you have any.
Thanks priority222
Is anyone still out there? What else do you think might cause the reverse gear case wobble,and how could i fix it before it tears anything up.Please give more advise if you have any.
Thanks priority222
Is anyone still out there? What else do you think might cause the reverse gear case wobble,and how could i fix it before it tears anything up.Please give more advise if you have any.
Thanks priority222
you could have a bad bearing in reverse box or bent your output shaft because you were running your chain to tight, not letting everything work with the suppension.
what about the bracket going to engine from reverse box is it line up and not putting the outside bearing in a bind when tighten down.
these reverse boxs are not hard to take apart.
if you think that is were the problem is i would take it a part check things over good clean and repack with good high temp. grease,you have been keeping plenty of grease in it?
pud
_________________ 2006 sunl 150b
Dr. pulley 10 gram sliders, 1500 torque spring,39 tooth sprocket,2000lb winch, red neck uni filter, 125 main jet at 1,450 elevation, drilled out exhaust,ngk iridium plug,performance intake
trying a set of 10gram rollers now
Im finally getting some time to work on this gear box wobble problem.Can someone give me a step by step direction on how to take the reverse gear box off ,so i dont mess anything up?
Im alittle nervous!
Priority222
I finally got my reverse gear box off and started the buggy , and could see that the shaft was wobbling when it would rotate.So now that i know my wobble problem,how do i go about taking the shaft off?step by step info would be greatly appreciated.Also,after i fix it,what do i need to know so it doesnt happen again?
Articles
