| Author |
Message |
| < Maintenance and Repairs - Mini Buggy ~ GY6 clutch??????? |
|
|
|
|
I have taken the clutch apart to replace the springs and rollers. I noticed that the arms were very ruff when trying to swing them out. I have taken them off and cleaned them. There were even some burrs on the pivot points besides all of the dust. There are 3 small round rubber pads that get exposed when the arms swings out. Should those pads be glued into place? Should I put any lube on the pivot points for the arms or leave them dry?
|
|
|
|
 |
Sponsor
|
|
|
|
|
|
|
I dont put any lube at all in that area. even the graphite powder will get on the pads and it will slip. as far as the rubber stops go, I just put them back in place, slide the arm down on them.
_________________
Blade buggies,Carter buggy's, ams (manco) , joyner, parts for almost anything
MRP dealer
Tucker Rocky Dealer
Vega Helmet dealer
I.T.P. tire and wheel dealer
www.mcdonoughpowersports.com
Eric Jackson
|
|
|
|
|
|
|
|
|
Thanks again. I don't know how far the arms extend so I was afraid that they rubber pieces might come off. It looked like one of mine was being held on by rust and the others 2 are stuck, probably by rust but I wasn't sure.
|
|
|
|
|
Sponsor
|
|
|
|
|
|
|
the pads not use any grease
_________________
reaction 150cc 10 grams roller mrp racing variator mrp 743/20/30 belt k&s clutch bell with oem clutch 1500 yelow spring 122 main jet honda trx 400 cdi exhaust front 21x7x/10 kenda tires 22x11x9 rear swap witch modified oem exhaust
|
|
|
|
|
|
Articles
