| Author |
Message |
| < Maintenance and Repairs - Mini Buggy ~ GY6 clutch??????? |
|
|
|
|
I have taken the clutch apart to replace the springs and rollers. I noticed that the arms were very ruff when trying to swing them out. I have taken them off and cleaned them. There were even some burrs on the pivot points besides all of the dust. There are 3 small round rubber pads that get exposed when the arms swings out. Should those pads be glued into place? Should I put any lube on the pivot points for the arms or leave them dry?
|
|
|
|
 |
Sponsor
|
|
|
|
|
|
|
I dont put any lube at all in that area. even the graphite powder will get on the pads and it will slip. as far as the rubber stops go, I just put them back in place, slide the arm down on them.
_________________
Blade buggies,Carter buggy's Atv's, parts and repairs. accessories for all makes.
Romaha products dealer
MRP dealer
Tucker Rocky Dealer
Vega Helmet dealer
I.T.P. tire and wheel dealer
www.mcdonoughpowersports.com
Eric Jackson
|
|
|
|
|
|
|
|
|
Thanks again. I don't know how far the arms extend so I was afraid that they rubber pieces might come off. It looked like one of mine was being held on by rust and the others 2 are stuck, probably by rust but I wasn't sure.
|
|
|
|
|
Sponsor
|
|
|
|
|
|
|
the pads not use any grease
_________________
reaction 150cc 10 grams roller mrp racing variator mrp 743/20/30 belt k&s clutch bell with oem clutch 1500 yelow spring 122 main jet honda trx 400 cdi exhaust front 21x7x/10 kenda tires 22x11x9 rear swap witch modified oem exhaust
|
|
|
|
|
|
Articles
