| Author |
Message |
| < Engine Clinic - Mini Off Road Buggy ~ 2005 talon 150 belt flopping at idle |
|
|
|
|
i have new rollers new clutch new belt belt only has an hour on it i took the back upcvt cover off and watched it the belt pulls up on the top of the variator at high speed and goes back down at lower speed on the clutch end the belt starts out on top and pulls down when speeding up when you slow down to a stop the belt goes to floppin bad if the cvt cover was on it would be hitting it and the belt is not going all the way back to the top of the pulley but if you hit the gas it will tighten back up and go back to the top also i have a new torque spring in
|
|
|
|
 |
Sponsor
|
|
|
|
|
|
|
have you checked the variator to see if one of the rollers hasn't turn side ways, not letting the variator open up all the way to let belt back down to the lowest point on variator.
maybe thats whats happening and the pressure of the 1500 torque spring is trying to get the belt all the way back up on the clutch pulley to go back in low gear, causing it to flop.
just a thought and are you running a 743-20-30 belt
pud
_________________
2006 sunl 150b
Dr. pulley 10 gram sliders, 1500 torque spring,39 tooth sprocket,2000lb winch, red neck uni filter, 125 main jet at 1,450 elevation, drilled out exhaust,ngk iridium plug,performance intake
trying a set of 10gram rollers now
|
|
|
|
|
|
|
|
|
like pud said check the rollers, and belt size, while you have it apart see if you can squeeze the clutch pulley apart and see if it sticks.
_________________
Blade buggies,Carter buggy's, ams (manco) , joyner, parts for almost anything
MRP dealer
Tucker Rocky Dealer
Vega Helmet dealer
I.T.P. tire and wheel dealer
www.mcdonoughpowersports.com
Eric Jackson
|
|
|
|
|
Sponsor
|
|
|
|
Articles
