any pictures out there for a blade 150dx carb hose wireing ?

Posts: 3 · Joined: 30 Apr 2008 Posts: 3 Pictures: 0

hi, need pictures on a blade 150 dx carb , forgot how the hoses all go on it and now it idles good but i can not get top end out of it it just goes flat, when i put it on jack stands and cleaned the carb with carb cleaner, it ran liked a raped ape for just about 3 minutes and then back to the same way.. maybe i just put the hoses on wrong,,, i hope

Posts: 1889

1. The upper inlet is the vacuum line from from the intake elbow
2. The lower left inlet is for fuel from your filter
3. The lowest inlet is actually an outlet for your bowl drain
4. Electric choke to 2-pin connector which has one line tapped off the AC stator phase and the other end running through a resistor to ground

Posts: 3 · Joined: 30 Apr 2008 Posts: 3 Pictures: 0

on the fuel tank there are two hoses the top one nearest fuel tank is the main fuel that goes to the one just above the over flow one for the fuel bowl?
and the one on the one that is below the top one is for vacum?

i have it so that the top one has a fuel filter and goes to the one above the over flow

the other one goes to the plastic t and goes to the side of the throttle side and one on the oposite side
then there is the one that is real short about 1 inch and it goes nowhere

thanks

next time i will take pictures if i am going to leave it for a few days