Wow Pud, good work!
You should come down here and get with Charlie when he begins his next creation. Theres no telling what you two could come up with. And if you come down here don't forget to bring your 5 gallon bucket of spare dozer parts _________________ DRIVE IT LIKE YOU STOLE IT!!!!!!!!!
DAZON 150 SINGLE SEAT
2.5inch rear wheel spacers
1.5inch front wheel spacers
UNI, 130jet, BIGE built intake tube, custom built exhaust, HO coil, adjustable CDI, iridium plug
is there a way to actualy do a front alignment on these carts? my problems is that my right tire points about 15 degrees right when my stering is centered and my left points true. I know my spindle is about 5 degrees of it but im replacing those A want to be able to fire it up as soon as they are done & the new wire harness is on. Im taking a trip this month with my cart & just want to know if i can do an alignment & if so, how???? _________________ stock yerf dog, on order parts: 1500 main spring, wire harness, 10 & 12g rolers, 1500cluch arm springs, 1/4" 4x4 front hubs, shocks, UNI (redneck)
is there a way to actualy do a front alignment on these carts? my problems is that my right tire points about 15 degrees right when my stering is centered and my left points true. I know my spindle is about 5 degrees of it but im replacing those A want to be able to fire it up as soon as they are done & the new wire harness is on. Im taking a trip this month with my cart & just want to know if i can do an alignment & if so, how????
jason go to service manual mini buggys in forum index and download the talon service manual, on page 70 of it it will show you what you need to do.
i know it is for a different buggy then the ones you are running but it is the same principle on how to get the front end lined back up
pud _________________ 2006 sunl 150b
Dr. pulley 10 gram sliders, 1500 torque spring,39 tooth sprocket,2000lb winch, red neck uni filter, 125 main jet at 1,450 elevation, drilled out exhaust,ngk iridium plug,performance intake
trying a set of 10gram rollers now
Thanks Pud _________________ stock yerf dog, on order parts: 1500 main spring, wire harness, 10 & 12g rolers, 1500cluch arm springs, 1/4" 4x4 front hubs, shocks, UNI (redneck)
I noticed my left rear wheel had some side-to-side play also. When I took it apart, I found that there was some clearance between the axle spline and the hub spline. The bearing was not the problem. I put some JB weld epoxy on the axle spline and reinstalled the hub. Tightened the nut and the problem was gone. _________________ ALZWEL (Frank)
Baja Motor Sports Reaction 150.
UNI filter, JC Whitney glass pack muffler, #130 main jet, 2000 rpm torque spring, yellow clutch springs, 12 gm sliders, speedometer/odometer, 24X11-10 rear tires.
Articles
