Booger'd up my threads! What size where they??

Posts: 19 · Rookie Joined: 19 Nov 2007 Posts: 19 Pictures: 0

As one thing leads to another, I booger'd up my threads on my drive pully shaft (the one the rollers are on). Any one know what size they are? I'm going to run a die on to see if I can clean up the outter threads (inner still look good). To me, it seems like they'd be M12x1.25??

Posts: 54

I ran into that problem once myself I went looking for a die to run over it and it was hard to find had to order one from napa, 2 days later and only 3 bucks I got my die. Your right on the size it's a 12x1.25

Posts: 19 · Rookie Joined: 19 Nov 2007 Posts: 19 Pictures: 0

Good thing is my brother owns a mechanic shop!!! Very Happy

Just hope he can dig that one out for me!

Thanks again!!

Shaun

Posts: 1161

I did the same thing. Bought a thread chaser off the snap-on truck. I don't remember the price, but it was less than 15 bucks.

Posts: 1194

i almost done the same thing, i let the air gun get a little wild with me.my tap and die set only goes to 10mm
i will put this in my little book
also is thread size the same on the shaft that holds the clutch assembly on.i know the nut is a little bigger than the 17mm
nut on variator.
pud

Posts: 1832

Be sure to write that down Pud. I may need to ask you what size that is one day Laughing

Posts: 1194

got ya

Posts: 19 · Rookie Joined: 19 Nov 2007 Posts: 19 Pictures: 0

My brother only had the 1.5 and the 1.75 Sad

But not to worry, ordered the thing from Matco Tools (online). It was $5.30 and shipping was about 7 bucks. Here is the link if it will help anyone.....http://www.matcotools.com/Catalog/toolcatalog.jsp?cattype=T&cat=2166